Velocity Edge GX325 Manual do Utilizador descarregar pdf (Página 11)

Plate Designations

SUPERCHANGER units are designed so that a ﬂ uid which

enters the “A” plate circuit (nozzles S1, S2, M1 or M2) always

ﬂ ows in the “A” circuit only. Fluid which enters the “B” plate

circuit (nozzles S3, S4, M3 or M4) always ﬂ ows in the “B” circuit

only. Facing the stationary frame, the right side is always the

“A” side, while the left side is always the “B” side. The “A” and

“B” term refers to the gasket orientation. When looking at the

gasketed side of the plate, an “A” plate becomes a “B” plate when

reversed (turned upside down). If the ﬂ ow comes in and out on

the left side, it is a “B” orientation.

NOTE: Every other plate has to be rotated 180° A-B-A-B in order

to prevent mixing. The ﬁ rst plate in the unit is called a “D” plate

and has a special gasket arrangement. This arrangement keeps

the ﬂ ow from contacting the stationary frame. The last is called

the “E” plate and is gasketed normally.

Items 1–4 indicate nozzle locations

To and from

additional

plates

Movable end frame side

A side

B side

Stationary end frame side

Figure 11

Plate orientation for the UX, SX, GC and GF Series.

Figure 12

Gasket orientation.

“A” plate

“B” plate

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Sem comentários

Velocity Edge GX325 Manual do Utilizador Página 11